How To Refresh Wood

DSC_0229I found this vintage message center made of awesome at Savers for $1.50. It needed a little work, but it was totally worth it. In particular, it needed a new cork board, and the wood was a little sad and dry. In the picture below, you can see especially on the chalkboard side that it was just in need of attention. It’s hard to tell in the picture, but whoever owned this first probably had it in their kitchen, and then stored in a garage. It had an icky greasy, dusty film when I bought it. I was able to get a lot of that off with Pledge, but it was still not perfect. Plus, when we took out the old cork board, there was some iffy stuff behind it.

Let’s just say, it needed a good cleaning.


Here’s what I used:

DSC_0225Murphey Oil Soap, Watco Rejuvenating Oil, Howard Feed-n-Wax, 000 steel wool, rags out of a cotton t-shirt, and water. I mixed 1/4 cup of the Murphey Oil Soap in a bucket of about a half-gallon of water, then used a rag first, followed by the steel wool to clean the frame. Always rub with the wood grain, and don’t soak the wood too much. You don’t want it to get water logged. I dried it off with a dry rag right away.

Here’s how it looked after the Murphey:

waxIt looked so much better just with cleaning that I almost stopped there. I went ahead with the oil though. Believe it or not, the hardest part of the whole project was getting the cap off the oil can! Once I (finally) did, I put a little on a piece of steel wool and rubbed it in with the grain of the wood. The steel wool helps get the oil into any scratches or nicks in the wood. The instructions said to let it sit 10 minutes and then dry it with a rag. I was a little afraid that the oil was just going to sit on top and get all sticky, but the wood must have drank that stuff in, because after 10 minutes there wasn’t much to dry off.

Here’s how it looked after the oil. The difference wasn’t huge, but the wood just seemed healthier afterward. I’m glad I went ahead with it.

oilFinally, I put a little of the wax on a soft rag and rubbed it in all over. Can I just say first that this stuff smells amazing? The best smelling cleaning product ever. The instructions said to leave it for 30 minutes, then buff it with a dry rag.

I was a little surprised by what a difference the wax made. It gave the wood a beautiful glow. Here’s how it looked at the end, with the original picture right under it for comparison.



Excluding waiting times, this whole job took me maybe 15 minutes. The results were kind of amazing. The oil and wax each cost about $8, but I only had to use a tiny bit for this project. I’ll be able to refresh several pieces of furniture without buying more. I bought them at Home Depot. Murphy Oil Soap is widely available. I bought mine at the grocery store for about $4.

We bought a four-pack of cork board squares at Wal-Mart for $5 and cut one down to replace the warped original cork.

Overall, I spent $27 on the board itself, plus all the materials to fix it up. I was left with the vast majority of the Murphy Oil Soap, Watco oil, and the wax, plus three cork boards. I’m going to call this about a $4 project. Not bad!

* * *

Did you know that my first novel, a young-adult dystopian story called Viral Nation, is scheduled for release by Penguin Books on July 2, 2013? Click here to like my author Facebook page. Thank you so much for your support!

* * *

Shared here: Check Me Out Saturday, Show and Tell Saturday, Saturday Nite Special, Saturday Spotlight, Think Pink Sunday, Nifty Thrifty Sunday, Not Bad Sunday, Coastal Charm,


Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s